Information, Signal / system, Field service / manufacturing – Runco PLASMAWALL XP-OPAL65DHD User Manual
Page 64: Pre l iminar y
48
PlasmaWall XP Series Installation/Operation Manual
PRE
L
IMINAR
Y
To reset the Custom 1 or Custom 2/THX memory preset to its factory-default state, select
it, press
or
to highlight Reset and press ENTER.
Signal / System: Select Information from the Main Menu, then choose either Signal or
System to display information about the current input signal (resolution, frequency, type et
cetera) and installed firmware versions, as well as other information that uniquely identifies
your DHD Controller and display device.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
Field Service / Manufacturing: The Field Service and Manufacturing menus are
password-protected and intended for use only by Runco service personnel and factory
technicians.
To save the settings for the current input and display mode to the
ISF Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 51).
Note
➤
Input Source
HDMI 1
Signal Format
1080p/60
Input Resolution
1920x1080
Vertical Freq
59.94 Hz
Horizontal Freq
67.500 kHz
Pixel Clock
148.500 MHz
Color Space
REC709
Sync Type
Separate
Memory Preset
ISF Night
Model
DHD3
Display Name
XP-50DHD
Output Resolution 1920x1080
Serial Number
00000000
Boot Version
3.0
Firmware Version
3.4
Micro Version
3.3