RoyalTek REV-2000 - Manual (Page 8)

RoyalTek GPS Receiver REB-2000/REB-12R REV-2000 Operational Manual
4
input range is from 2.5V ~ 3.1V DC.
P1
This is NMEA/SiRF protocol output/input port.
Please connect it to PC or Laptop RS-232
port.
P2
This is DGPS input port.
CON12
This is the socket for REB-2000/REB-2100.
Please refer the hardware interface section
for the pin assignment.
CON20
This is the socket for REB-12R2. Please
refer the hardware interface section for the
pin assignment.
Setup procedure
(1) Plug the REB-12R2 on the CON20
(2) Plug the active antenna into the external
antenna connector. The suitable view
angle of the active antenna is necessary.
Caution: Please do not put any metal
stuff on the antenna.
(3) Connecting the RS-232 cable between
REV-2000 P1 and PC.
(4) Plug the power core. (or connecting the
DC power input, 6.5V ~ 12V)
After you finish setup, it is like as follows:
Active
GPS antenna
AC
PC COM1 or COM2