RoyalTek REV-2000 - Manual (Page 14)

RoyalTek GPS Receiver REB-2000/REB-12R REV-2000 Operational Manual
10
(2) After you select the “Switch to NMEA Protocol”, it will show up a “Select NMEA Messages” dialog.
Select the NMEA Messages that you want to use.
(3) Determine the update rate for each NMEA
message
(4) Select the baud rate that you want to use
from the Baud Rate pull down menu.
(5) Click the OK button to save or Cancel
button to exit
(6) It will switch to NMEA protocol.
To Synchronize Protocol
When you don’t know what the
protocol/baud rate is set in REB-2100 or
REB-12R2, you can use this option to
synchronize protocol. Select the
Action/Synchronize Protocol and Baud Rate.
It will synchronize the protocol and Baud
Rate.
To Switch Trickle Power Parameters
from SiRFDemo.exe
There are two modes of low power operation: