Delimiter, Stx-etx, Offset edge – Rena DA615 User Manual

Page 40: Warming, Service rev, Adrc, Head

Printer functions

\text\etd\DA615\printerf

5.11

DA615 instruction manual

Delimiter < >

Individual page feed on/off

When the delimiter is activated, the two print characters "< >" are
recognized as the beginning and end of a page print with paper ejection.
This means that you should set the character "<" before a piece of text
that should go onto a new page and the character ">" after the text,
before the page is to be ejected.

STX-ETX

Print-out of a specific text area off/on

With this mode activated, only the text located between STX and ETX
will be printed.

STX = Start text

ETX = End text

Offset Edge

Offset edge of page by 0 – 304 mm

This function shifts the measured edge of the paper. To the user, it will
look as if the left margin had been increased.
This option is required for:

–

Windows programs in which the left edge cannot be changed (or
this is not desired).

–

Printing of large envelopes with Windows serial print, where the
desired print position cannot be set on the PC.

Warming

Warming the print cartridges

This function sets the time during which the cartridges are warmed.

min. lev1 lev2 lev3 lev4 max.

Service

Rev.

(=Revision)

The version number of the firmware is displayed together with the
prom number of the paper transport controller. Both numbers must be
specified if problems occur with the printer.

Adrc

Display of printed addresses from the initial operation of the printer.
This counter can be reset only by service personnel.

Head

Several print tests are performed for all cartridges:

–

the contacts to the nozzles are displayed in a grid pattern,

H1 = Head 1
H3 = Head 3

1 2