Rena DA615 - Manual (Page 18)

Addressing media
\text\etd\DA615/address 3.3 DA615 instruction manual
Hold-down set 4 – 1 must be replaced completely by set 7 – 10 (Accessories!). The
order numbers for the hold-down units are given in the variant list.
Switch the printer off ! Remove the two hexagon-socket screws (see arrow in left
diagram) of each hold-down unit and replace them by the corresponding variants
(see table).
Ensure correct assignment of
the hold-down units to the
print-head mounts!
Media feed direction def
Print-head
mount
H1
H2
H3
H4
Media feed direction
Def. Opp.
1 10
2 9
3 8
4 7
Media feed direction opp
Check these points before switching the printer on !
•
Check to ensure that the hold-down units of print-head mounts H4/H3 and
H2/H1 are all aligned in the feed direction.
•
When changing feed directions, activate switch (8) – after replacing the hold-
down units. The white arrow now applies. Compare the switch position with the
right-hand diagram.
Media feed direction
8 Def. Opp.
☞ The switch position is only effective after the printer has been switched on !
Any changes made via the menu or via control sequences are effective only
as long as the printer is switched on!
The direction can also be changed in programming mode or via control sequences.
Read the interface description relating to this point.