RCA BLD-6HD1 - Manual (Page 6)

9
TV/VCR
PROG
PR
PR MENU
EJECT
PAL/SEC
A.SEL
AV
SP/LP
INDEX
1 2 3
4 5 6
7 8 9
0 30
A
Manual tuning
Manual tuning allows you to tune in new stations or equipment such as a satellite receiver and so on.
1
Press MENU.
Choose ‘PR Preset’ by pressing
PR- then OK.
Choose ‘Manual Set’ by pressing
PR- then OK.
Press PR+ or PR- to select any
programme number that is not
being used, for example ‘----’ or
‘P-xx’.
Press OK to confirm.
Set the station you want:
◆ the programme location number,
◆ the broadcast system you want
(Aerial(CH) or Cable(CC)),
◆ You can directly enter the real
channel number with the 0 to 9
buttons, or search by pressing
/
,
◆ The fine tuning you can adjust, by
pressing /
,
◆ Change or create the station name.
Refer to page 10.
PR PRESET
AUTO SEARCH
MANUAL SET
PR ERASE
PR ALIGN
PR+/-:SELECT
OK:CONFIRM MENU:END
MANUAL SET
PR01 P-01 PR08 P-08
PR02 P-02 PR09 P-09
PR03 P-03 PR10 P-10
PR04 P-04 PR11 P-11
PR05 P-05 PR12 ----
PR06 P-06 PR13 ----
PR07 P-07 PR14 ----
PR+/-:SELECT
OK:CONFIRM MENU:END
2
3
4
5
These buttons are used
on the following two
pages.
MANUAL SET
PR+/-: UP/DOWN
/ : SELECT
OK:CONFIRM MENU:END
PR 04
RECEPTION AERIAL
AUTOSEARCH CH_ _
FINE TUNING
NAME
_ _ _ _
MANUAL SET
PR+/-: UP/DOWN
/ : SELECT
OK:CONFIRM MENU:END
PR 03
RECEPTION AERIAL
AUTOSEARCH CH 03
FINE TUNING
NAME
_ _ _ _
MANUAL SET
PR+/-: UP/DOWN
0/1: CHANGE/CREATE
OK:CONFIRM MENU:END
PR 03
RECEPTION AERIAL
AUTOSEARCH CH_ _
FINE TUNING
NAME
_ _ _ _
Press OK to store the picture you
want.
Tune in other stations (by
following step 3 onwards) or press
MENU to leave the tuning mode.
Your video has 99 available channel slots. It will only store programmes that are available in your
area. You can tune in other stations in any channel slot that is not already being used.
8
If the ‘CLOCK SET’ display is not already on the screen
press MENU.
Choose ‘VCR SET UP’ by pressing PR- twice, then OK.
Choose ‘CLOCK SET’ then press OK.
CLOCK SET
0-9:SETUP(HOUR)
/ :CORRECT
OK:CONFIRM MENU:END
TIME 11:41
DATE 11/08/2003(MON)
Setting time and date
1
2
Once the ‘CLOCK SET’ display is on the screen, move
to the position you want to change by pressing or
.
Use the number buttons 0 to 9 on the remote control
to enter the correct time and date.
Press OK to confirm the settings, and press MENU to
end.
CLOCK SET
0-9:SETUP(HOUR)
/ :CORRECT MENU:END
TIME - - : - -
DATE - -/- -/- - - -