Radio Shack TAD 1130 - Manual (Page 9)

9 Installation
7. Lift the base’s antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the bracket’s tabs into the base’s
lower tab slots, then press down on the
bracket’s clips and insert them into the
clip slots.
2. Plug one end of the supplied short mod-
ular cord into the TEL LINE jack on the
back of the base.
3. Insert the supplied AC adapter’s barrel
plug into the DC IN 9V jack on the back of
the base.
4. Route the adapter and modular cords
through the grooves on the bracket.
5. Plug the modular cord’s other end into
the wall plate jack, then align the
bracket’s keyhole slots with the wall
plate studs and slide the base down-
ward to secure it.
6. Plug the adapter into a standard AC out-
let.
7. Press and lift out the handset holder, flip
it over, then snap it back into place so it
holds the handset.
8. Lift the base’s antenna to a vertical posi-
tion.
Note: To mount the TAD directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the
bottom of the base.
Follow the steps under “On a Wall Plate or
Wall,” then apply these additional instruc-
tions for placement on a wall.
1. Drill two holes 3
15
/ 16
inches (100 mm) apart.
Then thread a screw into
each hole, letting the
heads extend about
5
/ 16
inch (8 mm) from the wall.
2. Plug one end of the sup-
plied long modular cord
into the
TEL LINE jack at the back of the
base.
3. Align the bracket’s keyhole slots with the
mounting screws and slide the base
downward to secure it.
3 15 /
16
"
5 /
16
"
43-1130.fm Page 9 Tuesday, May 30, 2000 1:22 PM