Radio Shack TAD 1130 - Manual (Page 13)

13 Installation
4. Press TALK or place the handset on the
base to hang up.
TURNING THE BASE’S
RINGER ON AND OFF
To turn off the base’s ringer, set RINGER on
the back of the base to OFF . You can still
make or receive calls using this phone. Tele-
phones on the same line (and the TAD’s
handset if it is away from the base) still ring
when there is an incoming call.
To turn on the base’s ringer, set RINGER to
ON .
SETTING THE RINGER
TONE/VOLUME
You can select one of four different ringer
tone/volume settings while the phone is not
in the talk mode. Press
VOL
8 8 8 8
or
9 9 9 9
to in-
crease or decrease the ringer level setting.
Note: The setting is not cyclic. If the ringer
does not change when you press
VOL
8 8 8 8
or
9 9 9 9
, try pressing the opposite arrow key.
SETTING THE NUMBER OF
RINGS
Set RING TIME on the side of the base to 3 , 5 ,
or T/S (Toll-Saver) to select how long the
TAD waits to answer a call (3 rings, 5 rings,
or toll-saver).
Note: If you plan to check messages by long
distance, set
RING TIME to T/S (see “Using
the Toll-Saver” on Page 20).
SETTING THE DAY/TIME
You must set the day of the week and time
so the TAD can record the correct day and
time of each message.
Note: Enter each key press within about 2
minutes. Otherwise, the TAD exits the time
setting process and you must begin again
with Step 1.
1. Hold down CLOCK until the TAD beeps.
The TAD announces the currently set
day and displays the day’s number (
0
for Sunday, 1 for Monday, and so on).
2. To change the day of the week, repeat-
edly press SKIP to move forward or
REPEAT to move backward to set the
correct day, press CLOCK .
3. The TAD announces the hour. To
change the hour, repeatedly press SKIP
or REPEAT until the correct hour dis-
plays, then press CLOCK .
4. The TAD announces the minutes. To
change the minutes, repeatedly press
SKIP or REPEAT until the correct minutes
display, then press CLOCK .
5. The TAD announces “AM” or “PM,” and
A or P appears. Press SKIP or REPEAT
to change this setting. Press CLOCK
again to set “AM” or “PM.” The TAD
beeps and announces the day and time.
To check the day and time, press CLOCK .
The TAD announces the currently set day
and time.
Note: When power fails, the clock retains the
current time. When the power is restored, the
clock starts counting again from the time the
power failed. You must reset the time.
43-1130.fm Page 13 Tuesday, May 30, 2000 1:22 PM