Radio Shack TAD 1130 - Manual (Page 19)

19 TAD Operation
To start recording a phone conversation,
hold down
MEMO on the base until the TAD
beeps and –– appears. To stop recording,
press PLAY/STOP or MEMO .
The TAD stores a recorded conversation as
a message (see “Playing Messages”).
Note: The TAD does not record conversa-
tions less than two seconds long, or that use
the speakerphone.
PLAYING MESSAGES
After the TAD has recorded a message, the
total number of messages stored appears in
the message counter window. If you have
new messages, the message counter flash-
es.
To play your messages, press PLAY/STOP .
The TAD announces the number of new and
old messages, then plays the new messag-
es. The message number appears in the
message counter window as each message
plays, and the TAD announces the day and
time of the call at the end of each message.
To play all messages after playing the new
messages, press
PLAY/STOP again.
To skip to the next message, press SKIP dur-
ing playback.
To replay the current message from the be-
ginning, press
REPEAT . If you press REPEAT
within about 2 seconds after a message be-
gins playing, the TAD replays the previous
message.
ADJUSTING THE TAD’S
VOLUME
To adjust the speaker’s volume, repeatedly
press
VOLUME
8 8 8 8
or
9 9 9 9
on the base. The
volume setting from 1 (lowest) to 10 (high-
est) appears in the message counter win-
dow.
DELETING MESSAGES
To delete the current message while it is
playing, hold down
DELETE until the TAD
beeps.
To delete all messages at once, while mes-
sages are not playing, hold down
DELETE on
the base until the TAD beeps and 0 appears
in the message counter window.
Note: You cannot delete new (unplayed)
messages. If you try to delete all messages
at once while you still have new messages,
the TAD beeps quickly five times and does
not delete any messages.
SETTING THE REMOTE
OPERATION PIN
The TAD’s two-digit remote operation PIN
(personal identification number) prevents un-
authorized remote access to your messages.
The PIN is preset to 80. Follow these steps
to change the PIN to any number from 00 to
99.
Note: If you wait more than 2 minutes be-
tween each keypress, the TAD exits the PIN
setting process. Start again at Step 1.
1. Hold down PIN until the TAD beeps and
00 appears in the message counter win-
dow.
2. Press SKIP to set the first digit of the PIN
higher or REPEAT to set it lower. Then
press PIN .
3. Press SKIP or REPEAT to set the second
digit of the PIN, then press PIN . The TAD
announces the new PIN.
To check your PIN at any time, press PIN .
The PIN appears in the message counter
window, and the TAD announces it.
43-1130.fm Page 19 Tuesday, May 30, 2000 1:22 PM