Connecting midi devices, What’s midi, Midi send channel settings – Roland RP101 User Manual
Page 38: Performance data (p. 38)
38
Connecting External Devices
Connecting MIDI Devices
By connecting an external MIDI device and exchanging
performance data, you can control the performances on one
device from the other. For instance, you can output sound from
the other instrument or switch tones on the other instrument.
■
What’s MIDI?
MIDI stands for Musical Instrument Digital Interface, an
international standard which allows performance information
to be communicated among electronic musical instruments and
computers.
The RP101 provides MIDI connectors, which allow
performance data to be exchanged with external devices.
When these connectors are used to connect the RP101 to
external devices, an even wider range of possibilities becomes
available.
Connection Examples
NOTE
To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
Playing the RP101 from a MIDI sequencer/Recording an
RP101 performance on a MIDI sequencer
fig.midi2.e
Set Local Off if you have connected the RP101 to a MIDI
sequencer. Refer to “Switching Local Control On and Off”
(p. 39). Also set your MIDI sequencer to MIDI Thru mode
(so that messages received at MIDI IN will be re-
transmitted without change from MIDI OUT). For details,
refer to the owner’s manual of your MIDI sequencer.
Perform on the RP101 to play a MIDI sound module
fig.midi1.e
■
MIDI Send Channel Settings
MIDI features sixteen MIDI channels, numbered 1–16. Simply
connecting a cable is not enough for communication to take
place. The connected devices must be set to use the same MIDI
channels. Otherwise, no sound will be produced, and no
sounds can be selected.
The RP101 receives all channels 1–16.
When the RP101 is turned on, Channel “1” is selected.
1.
While holding down the [METRONOME] and
[REVERB/KEY TOUCH] buttons, press the
appropriate key (C6–E 7) on the keyboard.
The MIDI transmit channel will switch to the number that
corresponds to the note you pressed.
RP101
MIDI Sequencer
OUT MIDI IN
RP101
MIDI Sound Module
THRU
OUT
MIDI
IN
7
2
4
9
11
14 16
8
1 3 5 6
10 12 13 15
C6
C8
RP101_e.book 38 ページ 2007年4月4日 水曜日 午前11時50分