Roland RP101 - Manual (Page 37)

37
Connecting External Devices
Connecting to Audio Equipment
You can connect audio devices to play the sound of the RP101
through the speakers of your audio system, or to record your
performance on a tape recorder or other recording device.
When connecting, please use an audio cable with a standard
phone plug (sold separately).
Connection Examples
NOTE
To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
NOTE
Some connection cables contain resistors. Do not use
cables that incorporate resistors for connecting to this unit.
The use of such cables can cause the sound level to be
extremely low, or impossible to hear. For information on
cable specifications, contact the manufacturer of the
cable.
Playing the sound of the RP101 through the speakers of
an audio system/Recording the performance of the
RP101 on a recording device
fig.audio1.e
❍ Use the following procedure when turning on the power.
1. Turn on the power of the RP101.
2. Turn on the power of the connected device.
3. Adjust the volume of each device.
When Recording RP101 Performances on a Recording
Device
4. Start recording with the connected device.
5. Perform on the RP101.
6. When the performance ends, stop recording on the
connected equipment.
Playing the sound of an audio device through the
speakers of the RP101
fig.audio2.e
❍ Use the following procedure when turning on the power.
1. Turn on the power of the connected device.
2. Turn on the power of the RP101.
3. Adjust the volume of each device.
NOTE
You cannot use the RP101 to adjust the volume of the
connected sound generating device.
Turning off the power
1. Set the volume of the RP101 and of the connected
devices to the minimum position.
2. Turn off the power of the RP101.
3. Turn off the connected equipment.
RP101
Input R/L
(Line In, Aux In)
RP101
Output R/L
(Line Out, Aux Out)
RP101_e.book 37 ページ ２００７年４月４日 水曜日 午前１１時５０分