Renesas Emulation Pod M3062NT3-RPD-E - Manual (Page 39)

( 37 / 84 )
Figure 3.8 Position for mounting pullup resistors
3.5 Installing and Removing Pullup Resistors
In this product, you cannot control pullup for ports P0 to P5 by pullup control registers (pullup control
register read/write are possible).
Mounting a pullup resistor inside this product allows pullup control. Mount the 51k Ω resistor array
supplied with this product to the port for which pullup control is required. For the mounting location,
refer to Figure 3.8 below.
CAUTION
Note on Installing and Removing Pullup Resistors:
• Always shut OFF power before installing or removing pullup resistors. Otherwise,
the internal circuits may be damaged.
• Install pullup resistors properly. Otherwise, the emulation pod will be damaged.
VCC2
P50
P51
P52
P53
P54
P55
P56
P57
VCC2
P00
P01
P02
P03
P04
P05
P06
P07
VCC2
P40
P41
P42
P43
P44
P45
P46
P47
VCC2
P10
P11
P12
P13
P14
P15
P16
P17
VCC2
P20
P21
P22
P23
P24
P25
P26
P27
VCC2
P30
P31
P32
P33
P34
P35
P36
P37
RM1 RM2 RM3
b7
P5 P0 P4 P1 P2 P3
b0
P6 P5