Renesas Emulation Pod M3062NT3-RPD-E - Manual (Page 38)

( 36 / 84 )
(2) Jumper Switches JP1 and JP2 on the M30620T3-PRT Board (MCU-dependent 1)
Table 3.4 Switch settings of the M3062NT3-RPD-E (3/3)
A18_SEL JP1
VDDI0
Signal Switch Setting Description
JP2
A18_SEL
4M
1M
(Factory-setting)
Use this setting when not using the memory
space expansion mode.
Use this setting when using the memory
space expansion mode.
A18_SEL
4M
1M
Use this setting.
VCC1 > VCC2
JP2 Vcc1
||
VCC2
(Factory-setting)
VDDI0
VCC1 > VCC2
JP2 Vcc1
||
VCC2
VDDI0
Do not use this setting.
CAUTION
Note on Switch Settings:
• Always shut OFF power before changing switch settings.