Roland VIMA RK-100 - Manual (Page 52)

52
Connecting other equipment
You can connect a video device to the VIMA and directly output the image from that video device to a television or
other display equipped with a video connector.
fig.ConnectTV-e.eps
1. Switch off power to the VIMA, and the television
and video device you’ll be connecting.
2. Connect the video device to the VIMA.
Use a video cable to connect your video device to the
VIMA’s VIDEO connector.
3. Connect the VIMA to your television.
4. Switch on the video device’s power.
5. Switch on power to the VIMA.
6. Switch on the television.
The image from the video input will appear on the
television.
The image received at the video input will be output
without change from the VIDEO connector. It will not
be shown on the VIMA’s display.
There will be a difference in volume depending on
the video device that’s connected.
Turning the power off
You must observe the following order when you turn off the
power.
1. Switch off the power on the television.
2. Minimize the VIMA’s volume.
3. Switch off the VIMA’s power.
4. Switch off the video device’s power.
Connecting a television
Video cable
The VIMA’s
rear panel
Television or other display
equipped with a video connector
Video cable
Portable audio player etc.
VIDEO
connector
NOTE
NOTE
RK-100-e.book 52 ページ ２００６年７月２０日 木曜日 午前１０時２０分