Roland VIMA RK-100 - Manual (Page 14)

14
Before you play
1. Make sure that the [Power On] switch located
at the left side of the keyboard is off (in the
upward position).
2. Connect the AC adaptor to the VIMA, and plug
the power cord into an AC outlet.
You must use the power cord included with the VIMA.
fig.ACcord-e.eps
924
* To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the DC IN jack, anchor the power
cord using the cord hook, as shown in the illustration.
941
Once you’ve got everything connected properly, you can
turn on the power using the following procedure. If you
fail to perform these steps in the correct order, you risk
causing a malfunction or damaging your speakers.
Turning the power on
1. Turn the [VOLUME] knob all the way toward
the left to minimize the volume.
fig.VolumeMin-e.eps
2. Press the [Power On] switch.
fig.PowerOn-e.eps
942
Due to a circuitry protection feature, this unit requires
a few moments after power is turned on before it is
ready for normal operation.
3. Use the [VOLUME] knob to adjust the volume
(p. 15).
Turning the power off
1. Turn the [VOLUME] knob all the way toward
the left to minimize the volume.
fig.VolumeMin-e.eps
2. Press the [Power On] switch.
The screen goes blank and the power is turned off.
Getting ready to play
Connecting the power cord
To the
Power
Outlet
The cord of
the supplied
AC Adaptor
Cord Hook
Turning the power on/off
NOTE
NOTE
RK-100-e.book 14 ページ ２００６年７月２０日 木曜日 午前１０時２０分