Radio Shack TAD-1015 - Manual (Page 20)

20
SETTING THE REMOTE
OPERATION PIN
The PIN (personal identification num-
ber) permits remote access to the
TAD. The PIN can be any number
from 00 to 99.
Note: The default setting is 00.
1. Press REMOTE on the handset so
the BATT LOW indicator lights
green.
2. Press PIN/ on the keypad, then
enter your two-digit PIN.
3. Press PIN/ on the keypad again.
A beep sounds and your PIN is
stored.
Note: If you make an error, the TAD
beeps 5 times. Repeat the steps to
enter the number correctly.
SETTING THE DAY AND
TIME
You must set the day and time so the
TAD can record the correct day and
time of each message.
1. Press REMOTE on the handset so
the BATT LOW indicator lights
green.
2. Press TIME SET/9 on the keypad.
Then enter the day of the week
using the number keys.
3. Using the number keys, enter the
hour. Precede a single-digit hour
with a zero.
4. Using the number keys, enter the
minutes. Precede a single-digit
minute with a zero.
To Enter: Press:
Sunday 1
Monday 2
Tuesday 3
Wednesday 4
Thursday 5
Friday 6
Saturday 7
43-774.fm Page 20 Friday, August 13, 1999 3:14 PM