Radio Shack TAD-1015 - Manual (Page 12)

12
PREPARATION
CONNECTING AND
CHARGING THE
BATTERY PACK
The TAD-1015 comes with a recharge-
able nickel-cadmium battery pack in
the handset. Before using your phone,
you must connect the battery, then
charge it for about 18 hours.
1. Remove the screw from the bat-
tery compartment cover on the
bottom of the handset, then press
down and slide off the handset’s
cover.
2. Plug the battery pack’s plastic
connector into the phone’s socket.
The connector fits only one way.
3. Replace the cover and tighten the
screw.
4. To charge the battery pack, simply
place the handset on the base.
The CHARGE indicator on the
base lights.
Recharge the battery pack when the
BATT LOW indicator flashes.
Notes:
• If the CHARGE indicator does not
light when you place the handset
on the base, be sure the battery
pack and AC adapter are correctly
and securely connected.
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work
and you might hear an error tone.
If this happens, return the handset
to the base for 5 seconds.
43-774.fm Page 12 Friday, August 13, 1999 3:14 PM