Radio Shack TAD-1015 - Manual (Page 15)

15
TELEPHONE OPERATION
MAKING AND
RECEIVING CALLS
To make or answer a call, lift the hand-
set. Or, if the handset is off the base,
press
TALK . The BATT LOW indicator
on the handset and the IN USE indica-
tor on the base light.
To end a call, place the handset on the
base or press
TALK on the handset.
Note: If you press TALK to hang up
and the phone does not disconnect,
press
TALK again while holding the
handset closer to the base or place
the handset on the base.
CHANGING THE
CHANNEL
If you notice interference, static, or
noise during a call, press
CH (channel)
on the handset to find a clearer chan-
nel.
The TAD-1015 changes to a different
channel each time you press
CH .
Note: If the handset is too far from the
base, the channel might not change.
Move closer to the base and try again.
USING REDIAL
REDIAL lets you dial the last number
dialed. When you hear a dial tone, sim-
ply press
REDIAL .
Notes:
• The redial memory holds up to
32 digits, so you can redial long-
distance as well as local num-
bers.
• The redial memory also holds
pause entries. See “Entering a
Pause” on Page 18.
• The redial memory does not store
a flash entry or any digits you
press after
FLASH (see “Using
Flash” on Page 16).
43-774.fm Page 15 Friday, August 13, 1999 3:14 PM