Radio Shack 2-Line 900 MHz Handsfree Cordless Phone - Manual (Page 21)

21 Operation
5. You can write down the stored numbers on the memory
index card underneath the base.
Note: If you hear three short beeps, you did not store the num-
ber successfully. Start again from Step 1.
Entering a Pause in Memory Number
In some telephone systems, you must dial an access code (9,
for example) and wait for a second dial tone before you can dial
an outside number. You can store the access code with the
phone number. However, if you do, you should also store a
pause after the access code to allow the outside line time to
connect. After entering the access code, press
REDIAL/PAUSE
to enter a 2-second pause.
Dialing a Stored Number
1. Press L1 or L2 .
2. When you hear the dial tone, press MEMORY , then the
memory location number ( 1 – 0 ). The phone dials the num-
ber.
Chain-Dialing Service Numbers
For quick recall of numbers for special services (such as alter-
nate long distance or bank by phone), store each group of num-
bers in its own memory location.
To call special services, dial the service’s main number. At the
appropriate place in the call, press
MEMORY , then the number
for the location where the additional numbers are stored.
43-1701.fm Page 21 Wednesday, September 20, 2000 8:48 AM