Radio Shack 2-Line 900 MHz Handsfree Cordless Phone - Manual (Page 10)

10 Preparation
To connect the battery pack, line up
the slots on the battery pack with
the posts on the back of the keypad.
Press down and slide the battery
pack forward until the latch clicks.
To charge the battery
pack, place the keypad in
the base’s front charging
slot. The CHARGE indica-
tor at the front of the unit
lights.
To charge the spare bat-
tery pack, place it in the
rear charging slot with its
latch end facing down and
its contacts toward the rear of the base. The CHARGE indicator
between the two slots lights.
Notes:
• Recharge the battery pack anytime the LOW BATT indica-
tor flashes, or if the keypad beeps while you are on the
phone.
• When you first use the phone after charging or recharging
the battery pack, the phone might not work. Return the key-
pad to the base for about 5 seconds to reset the security
access-protection code.
• About once a month, fully discharge the battery pack by
keeping the phone off the base until the LOW BATT indica-
tor flashes, or if the keypad beeps while you are on the
Battery
Pack
L1
L2
PAGE CHARGE
Antenna
Battery
Charging
Slot
Keypad
Charging
Slot
CHARGE
43-1701.fm Page 10 Wednesday, September 20, 2000 8:48 AM