Radio Shack 2-Line 900 MHz Handsfree Cordless Phone - Manual (Page 19)

19 Operation
USING FLASH
FLASH provides the electronic equivalent of a switchhook signal
for special phone services such as Call Waiting.
For example, if you have Call Waiting, press FLASH to answer
an incoming call without disconnecting the current call. Press
FLASH again to return to the first call.
Note: If you do not have any special phone services, pressing
FLASH might disconnect your current call.
USING TONE SERVICES ON A PULSE LINE
Some special services, such as bank-by-phone, require tone
signals. If you have pulse service, you can still use these tone
services by following these steps.
1. Dial the service’s main number.
2. When the service answers, press
∗
/TONE . Any additional
numbers you dial are sent as tone signals.
3. After you complete the call, press L1 or L2 . The phone
automatically resets to pulse dialing.
USING PAGE
You can send a page to the keypad to locate it when it is away
from the base and not in use.
1. Press PAGE on the base. The keypad rings for about 15
seconds.
43-1701.fm Page 19 Wednesday, September 20, 2000 8:48 AM