Right side of the unit. see, Figure f-1, Installing a single unit – RAD Data comm ASM-20 User Manual
Page 71: Installing two units, Figure f-2
ASM-20 Installation and Operation Manual
Appendix F Unit Case Assembly
Installation of the Unit Case into a 19-inch Rack
F-3
Short
Bracket
Left-Hand
Unit
Right-Hand
Unit
Rail
Short
Bracket
Rail
Figure F-2 Rack Adapter Components for Installation of Two Units
To install two units:
1. Fasten one long side rail to each unit (right side to one unit, left side to the
other unit) using the four screws and flat washers supplied. The side rails must
be attached in opposing fashion, the narrow flange of the first rail opposite the
wide flange of the second rail.
2. Attach one short bracket opposite the side rail on each unit using the four
screws and flat washers supplied.
3. Slide the side rail of one unit into the side rail of the other unit, fastening the
two units together (See