RAD Data comm ASM-20 - Manual (Page 29)

ASM-20 Installation and Operation Manual Chapter 2 Installation and Setup
Setting Internal Jumpers and Switches 2-5
Table 2-2. ASM-20 Strap Selection Settings (Cont.)
Jumper and
Switch Identity Function Possible Settings **
SW2
ASYNC LENGTH
(3 dip switches)
Select character length in async mode
(see Table 2-3. Async Character Length Setting
for further explanation).
Selects the stop bit reduction rate to be used in async
mode.
S1 S2 No. Bits
OFF OFF 8
ON OFF 9
OFF ON 10
ON ON 11
S3
OFF 25%
ON 12.5%
SW3
Baud Rate (kbps)
Selects the data rate. Rate
0) 256 kbps
1) 192 kbps
2) 144 kbps
3) 128 kbps
4) 115.2 kbps
$
5) 112 kbps
6) 96 kbps
7) 72 kbps
8) 64 kbps
9) 57.6 kbps $
A) 56 kbps
B) 48 kbps
C) 38.4 kbps
$
D) 32 kbps
E) 28.8 kbps $
F) 19.2 kbps $$
$ Async baud rate
$$ Async/Sync baud rate
** Factory settings are shown in bold.