Roberts Radio RDK-2 - Manual (Page 9)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
8
Using the touch panel
Your radio has a stylish touch panel instead of conventional buttons. This
is designed so that it is easy to clean using a slightly damp cloth. Do not
use solvents.
Be sure to dry of any moisture from the touch panel after cleaning, since this
may otherwise affect the reliability of the touch panel sensor system.
To operate the buttons simply touch the button area with the tip of a fi nger
for about half a second. Some operations such as storing radio presets,
require a longer operation of the button. In this case simply keep your
fi nger held on the button area for 2-3 seconds until the display on the
radio shows that the command has been accepted.
You may fi nd that at fi rst, the radio does not always detect that you have
touched a button. If so, try touching with a little more pressure, a little
higher or lower, or for slightly longer. You will soon fi nd the optimum touch
needed to control your radio.
Using an alternative aerial
Your radio is supplied with a simple wire aerial. This will be satisfactory in
the majority of installations. However, if reception is poor in your kitchen,
you may wish to consider connecting the radio to an alternative aerial.
The supplied aerial is secured by a small plastic cover. Use a cross-head
screw driver to remove this cover. The aerial may then be removed by
pulling with a twisting action.
Once the aerial has been removed, a standard F-type socket is available
to which an alternative aerial may be connected.