Roberts Radio RDK-2 - Manual (Page 21)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
20
Operating your radio - Search tuning FM
1. Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Touch the On/Standby button to switch on your radio.
3. Touch the Band button to select the FM band.
4. Touch the Auto tune button, your radio will scan in an upwards direc-
tion (low frequency to high frequency) and stop automatically when it
fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
6. To fi nd other stations, touch the Auto tune button as before.
7. To scan the FM band in a downwards direction (high frequency to
low frequency) touch the Auto tune button for 2-3 seconds and then
release.
8. When the waveband end is reached your radio will recommence tuning
from the opposite waveband end.
9. Adjust the Volume control to the required setting.
10. To switch off your radio touch the On/Standby button.
4
2
3
9
9
6,7