Roland MP-60 - Manual (Page 9)

9
Before You Start Playing
Turning the Power On and Off
NOTE
Turn on power to your various devices in the order specified.
By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
To turn the power on, turn the [VOLUME] knob all the
way down, and then press the [Power] switch.
The power will turn on, and the Power indicator at the
left front of the MP-60 will light.
After a few seconds, you will be able to play the
keyboard to produce sound.
Use the [VOLUME] knob to adjust the volume.
NOTE
This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
fig.00-06.e
To turn the power off, turn the [VOLUME] knob all the
way to the left, and press the [Power] switch.
The Power indicator at the left front of the MP-60 will go
dark, and the power will be turned off.
NOTE
If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to Power Supply (p. 5).
Adjusting the Sound’s
Volume and Brilliance
Turn the [VOLUME] knob to adjust the overall volume.
Press the [BRILLIANCE] button to adjust the
brightness of the sound.
Select one of the three available settings to obtain the
desired brilliance.
fig.00-07.e
About the Pedals
The pedals have the following functions, and are used
mainly for piano performance.
fig.00-08.e
Damper pedal (right pedal)
While this pedal is pressed, notes will be sustained even after
you take your fingers off the keys.
On an acoustic piano, holding down the damper pedal will
allow the remaining strings to resonate in sympathy with the
sounds that you played from the keyboard, adding a rich
resonance.
The MP-60 simulates this sympathetic resonance.
You can change the amount of resonance applied with
the damper pedal. Please refer to “Changing the Damper
Pedal’s Resonance” (p. 26).
Sostenuto pedal (center pedal)
This pedal sustains only the sounds of the keys that were
already played when you pressed the pedal.
Soft pedal (left pedal)
When you hold down this pedal and play the keyboard, the
sound will have a softer tone.
About the adjuster
When you move the MP-60 or if you feel that the pedals are
unstable, adjust the adjuster located below the pedals as
follows.
❍ Rotate the adjuster to lower it so that it is in firm contact
with the floor. If there is a gap between the pedals and
the floor, the pedals may be damaged. In particular
when placing the instrument on carpet, adjust this so
that the pedals firmly contact the floor.
fig.00-09.j
[BRILLIANCE]
button’s indicator
Off Red Green
Brilliance Medium Mellow Bright
Power Indicator
Power
Soft Pedal
Sostenuto Pedal
Damper Pedal
Adjuster
MP-60_e.book 9 ページ ２００５年３月２３日 水曜日 午後５時５２分