Raypak LONMARK Y-200 - Manual (Page 16)

16
Keypad
Normal Mode
Move to next screen
Not active except in special modes
Move to previous screen
Not active except in special modes
To access programming mode: Press and hold
"MODE" button for 4 seconds. If no button is
pressed while in PROGRAM mode for 30 seconds,
screen returns to normal mode
Increase selected parameter
Move to next programmable
parameter
Decrease selected parameter
Move to previous programmable
parameter
When in PROGRAM mode, cursor is blinking on first
settable parameter. If no button is pressed for 30
seconds, screen returns to NORMAL mode. Press
"MODE" button to store change and return to NOR-
MAL mode
Push the "MODE" button to turn off
the alarm horn
Once programming is finished, press the SW3 reset button on the motherboard to save the new
programming.
Program Mode