Roland MC-909 - Manual (Page 45)

45
Pattern editing
Pattern Mode
Erase
This operation erases all or part of the data from a pattern.
Delete Measure
This operation deletes unwanted measures from a pattern, and joins
the remaining measures together.
If a part contains data following the deleted region, the performance
data of that part will be shortened by the corresponding length. If
you specify all parts as the object of the delete operation, the pattern
itself will be shortened.
fig.Delete
Insert Measure
This operation inserts blank measures between the specified
measure of a pattern and the following measure. If you want to add
more playing in the middle of a existing performance, use this
operation to insert one or more blank measures, and then record the
additional performance. The inserted measures will have the same
time signature as the time signature preceding the insert location.
fig.Insert
Transpose
This operation shifts the note numbers (pitch) of one or more parts in
the pattern. You can transpose the notes in a range of +/-2 octaves.
Change Velocity/
Change Duration
This operation modifies the velocity (strength) or duration (the
length that the note is held) of the notes recorded in the pattern.
You can use Change Duration to give the overall performance a
staccato feel or tenuto feel.
If this operation would result in a velocity greater than 127 (or less
than 1), the resulting velocity data will be limited to 127 (or 1).
Shift Clock
This operation shifts the timing of the performance data recorded in
the pattern backward or forward in units of one clock (1/96th of a
beat). Use this when you want to slightly shift the overall
performance.
Parameter Range Explanation
Event ALL, NOTE,
PROG, CC,
BEND, PAFT,
CAFT, SYS-EX,
BPM, MUTE Data to be erased
Note Minimum 0 (C-1)–127 (G9) Note region to be erased
* This can be specified
only if Event is set to
“NOTE.”
Note Maximum
Min CC#0–CC#127 Control change message
to be erased
Messages in the speci-
fied range will be
erased
* This can be specified
only if Event is set to
“CC.”
Max
Parameter Range Explanation
Insert Meas 1–998 (Max) Number of measures to insert
* You cannot specify a number
that would cause the pattern to
exceed 998 measures.
1 2 3 4 5 6
1 2 3 4 5
1 2 3 4 5 6
1 2
2
3 4 5
Parameter Range Explanation
Value -24– +24 Amount of transposition
Note Minimum 0 (C-1)–127 (G9) Range of notes to be trans-
posed
Note Maximum
Parameter Range Explanation
Type VELOCITY,
DURATION Data to be modified
VELOCITY:
Strength of the notes
DURATION:
Length of the notes
When Type is “VELOCITY”
Value -99– +99 Amount by which the ve-
locity is to be changed
Note Minimum 0 (C-1)–127 (G9) Range of notes whose ve-
locity is to be changed
Note Maximum
When Type is “DURATION”
Value -960– +960 Amount by which the du-
ration is to be changed
Note Minimum 0 (C-1)–127 (G9) Range of notes whose du-
ration is to be changed
Note Maximum
Parameter Range Explanation
Value -960– +960 Amount of clock shift
Event ALL, NOTE,
PROG, CC,
BEND, PAFT,
CAFT, SYS-EX,
BPM, MUTE Type of data whose timing
is to be adjusted
Note Minimum 0 (C-1)–127 (G9) Range of notes for which
the timing is to be adjusted
Note Maximum
MC-909_Ref_e.book 45 ページ ２００５年３月１日 火曜日 午後３時２９分