Roland MP-70 - Manual (Page 9)

9
Before You Start Playing
■ Using the Headphones Hook
Whenever you are not using the headphones, you can hang
them on the headphones hook at the lower left of the MP-70.
Attaching the Headphones Hook
Press and twist the headphones hook included with the MP-
70 into the hole in the bottom of the MP-70 (refer to the figure
below). Turn the wing nut of headphones hook to secure the
headphones hook.
Turning the Power On and Off
NOTE
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction and/
or damage to speakers and other devices.
To turn the power on, turn the [VOLUME] knob all the
way down, and then press the [Power] switch.
The power will turn on, and the Power indicator at the
left front of the MP-70 will light.
After a few seconds, you will be able to play the
keyboard to produce sound.
Use the [VOLUME] knob to adjust the volume.
NOTE
This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
fig.00-06.e
To turn the power off, turn the [VOLUME] knob all the
way to the left, and press the [Power] switch.
The Power indicator at the left front of the MP-70 will go
dark, and the power will be turned off.
NOTE
If you need to turn off the power completely, first turn off the
Power switch, then unplug the power cord from the power
outlet. Refer to
Power Supply (p. 5).
Adjusting the Sound’s
Volume and Brilliance
Turn the [VOLUME] knob to adjust the overall volume.
Press the [BRILLIANCE] button to adjust the
brightness of the sound.
Select one of the three available settings to obtain the
desired brilliance.
fig.00-07.e
Headphones Hook
Wing Nut
Power Indicator
Power
[BRILLIANCE]
button’s indicator
Off Red Green
Brilliance Medium Mellow Bright
MP-70_e.book 9 ページ ２００６年３月２９日 水曜日 午後４時１７分