Roland MP-70 - Manual (Page 22)

22
Chapter 2. Performance
Changing the beat of metronome
4
Hold down the [SONG/TEMPO] button, and press the [-] or [+] button.
The currently selected beat will be displayed.
If you hold down the [SONG/TEMPO] button and press the [-] or [+] button, the
beat will change.
If you hold down the [SONG/TEMPO] button and press the [-] and [+] buttons
simultaneously, the beat will go back to what it was before you changed it.
fig.disp-beat
Stopping the metronome
5
Once again press the [METRONOME/COUNT IN] button, getting the
button to go dark.
The metronome will stop.
■ Changing the Metronome Volume
The volume of the metronome can be adjusted, with nine volume levels available.
1
Hold down the [METRONOME/COUNT IN] button and press the [-] or
[+] button.
The currently specified volume will be displayed.
Continue to hold down the [METRONOME/COUNT IN] button, and press the [-]
or [+] button to sound the metronome, and change the volume.
fig.disp-metrovol
Display beat Display beat
2.2 2/2 6.4 6/4
0.4 Only weak beats 7.4 7/4
2.4 2/4 3.8 3/8
3.4 3/4 6.8 6/8
4.4 4/4 9.8 9/8
5.4 5/4 12.8 12/8
NOTE
It is not possible to change the
beat during song playback or
recording.
When you hold down the
[SONG/TEMPO] button, the
currently specified metronome
beat will be displayed.
Correspondence between
beat and tempo display
Beat Tempo Value
2/2 =10–125
x/4 =20–250
x /8 =40–500
This is set to “4” when the
instrument is turned on.
When you hold down the
[METRONOME/COUNT IN]
button, the currently specified
metronome volume will be
displayed.
NOTE
When the metronome volume
is set to “0,” the metronome
sound does not play.
MP-70_e.book 22 ページ ２００６年３月２９日 水曜日 午後４時１７分