Radio Shack ET-1110 - Manual (Page 21)

21
MEMORY DIALING
You can store up to 20 phone numbers
and names in memory, then dial a stored
number by pressing a two-digit memory
location number.
Each stored number can be up to 24 dig-
its long, and each name can contain up
to 16 characters.
Storing a Number and Name in
Memory
Notes:
• If T/P is set to P and you want to use
tone dialing for a memory number,
you must store a
as the first entry
of the number you want to tone dial.
• Do not store a number with both
pulse and tone entries in the same
memory location. This could result
in a wrong number being dialed.
• Each pause (see “Entering a Pause”
on Page 22) and tone entry ( )
uses one digit of memory.
• To keep your accounts secure, we
recommend you do not store your
personal access code for services
such as bank-by-phone in a memory
location.
• An error tone sounds and the phone
exits the programming mode if you
wait more than 15 seconds between
each keypress or enter more than
24 digits. You must start over at
Step 1.
1. Press MEM . PROG (programming)
appears.
2. Enter the number you want to store.
The number appears on the display.
If you enter an incorrect digit, press
DELETE to delete the last entered
digit. Then enter the correct digit.
3. To enter a name, press SETUP . A
flashing cursor appears.
Refer to the letters on the number
keys to select the desired letter.
Press the desired letter once for the
upper case letter, and press twice
for the lower case letter. For exam-
ple, to enter John: press
5 once; up-
per case J appears. Then press 6
six times; lower case o appears.
Press 4 four; lower case h appears.
Finally, press 6 four times; lower
case n appears.
43-1110.fm Page 21 Wednesday, August 18, 1999 8:22 AM