Radio Shack ET-1110 - Manual (Page 13)

13
CONNECTING AND
CHARGING THE BATTERY
PACK
The ET-1110 comes with a rechargeable
nickel-cadmium battery pack in the
handset but not connected. Before using
your phone, you must connect the bat-
tery pack and then charge it for about 15
hours.
1. Press down and slide off the com-
partment cover as shown.
2. Plug the battery pack’s connector
into the socket in the compartment.
The connector fits only one way.
Note: For easier battery pack con-
nection, lift it out of the compart-
ment, insert its connector into the
socket, then replace the battery
pack inside the compartment.
3. Replace the cover.
To charge the battery pack, simply place
the handset on the base. The CHARGE
indicator on the base lights.
Recharge the battery pack when
appears on the handset’s display.
Notes:
• You can place the handset on the
base face down or face up without
removing the belt clip. If you want to
use the hanging hole on the back of
the handset to place the handset on
the wall-mounted base face-up, re-
move the belt clip (see “Removing
the Belt Clip” on Page 27). However,
the battey pack will not fully charge
in this position.
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work and
you might hear an error tone when
you press
TALK . If this happens, re-
turn the handset to the base for
about 6 seconds. This resets the se-
curity access protection code.
CHARGE
Indicator
Low Battery Indicator
43-1110.fm Page 13 Wednesday, August 18, 1999 8:22 AM