Roland PRELUDE MUSIC KEYBOARD 2 - Manual (Page 18)

18
Creating a new Style
This function modifies the dynamics of the specified region.
1. In the “Style Edit Menu,” select “7. Change Velocity” and
press [ENTER].
The STYLE EDIT CHANGE VELOCITY screen will appear.
2. Use [ ] [ ] [ ] [ ] to move the cursor to the
parameter you want to change, and use the VALUE dial to
make the desired setting.
3. Select “EXECUTE” and then press [ENTER].
It is not possible to restore the data to its original state after
executing this operation.
This function modifies the durations of the notes in the
specified region.
1. In the “Style Edit Menu,” select “8. Change Gate Time”
and press [ENTER].
The STYLE EDIT CHANGE GATE TIME screen will appear.
2. Use [ ] [ ] [ ] [ ] to move the cursor to the
parameter you want to change, and use the VALUE dial to
make the desired setting.
Modifying the note dynamics
(Change Velocity)
Parameter Value Explanation
PART
ADrum,
ABass,
Acc1–6,
ALL
Selects the Style part whose
velocity is to be modified.
CHORD
Maj, min,
7th
Selects the chord.
DIVISION
INT1–4,
MAIN1–4,
FILL1–4,
END1–4
Selects the division.
From
(MEAS:
BEAT: TICK)
0001: 01:
000–
Specifies the beginning of the
region whose velocity is to be
modified.
To (MEAS:
BEAT: TICK) 0001: 01:
000– Specifies the end of the region
whose velocity is to be modified.
Bias -99–99
Specifies the amount by which
the velocity is to be modified.
Magnify 0–200%
Allows you to make the velocity
more uniform, or to decrease or
increase the dynamics.
If Magnify is set near 0%, the
velocity will be adjusted toward
64, and the Bias value will be
added to each velocity value.
This allows you to make the
velocity more consistent while
adjusting it as desired.
If Magnify is set to 101% or
higher, velocities greater than
64 will be increased while
velocities below 64 will be
decreased, increasing the
dynamics.
If Magnify is set to 100%, the
velocity will not change.
Note
Range Min
C–(Note
Range
Max value)
Specifies the lowest pitch whose
velocity is to be modified.
Note
Range Max
(Note
Range Min
value)–G9
Specifies the highest pitch
whose velocity is to be modified.
Modifying the note durations
(Change Gate Time)
Parameter Value Explanation
PART
ADrum, ABass,
Acc1–6, ALL
Selects the Style part
whose gate times are to
be modified.
CHORD Maj, min, 7th Selects the chord.
DIVISION
INT1–4,
MAIN1–4,
FILL1–4,
END1–4
Selects the division.
From
(MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the beginning
of the region whose gate
times are to be modified.
To (MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the end of the
region whose gate times
are to be modified.
Parameter Value Explanation
Prelude_OM_Ver2.book Page 18 Wednesday, September 9, 2009 5:38 PM