Rhinotek F-4243C - Manual (Page 41)

ASSEMBLY
1625 01/11 Assembly Section 3-7
© 2011 Alamo Group Inc.
ASSEMBL
Y
Installing Grille Guard (Optional)
1. Position grille guard (4) on front of tractor.
2. Secure with HHCS M14 x 50MM (18) and M14 Lockwashers (19).
3. Torque bolts after all have been installed using General Torque Specifications. (See Maintenance
Section).
Installing Left and Right Mid-mounting Brackets
(Figure 1)
1. Lift right midmounting bracket (1) with overhead hoist. Fasten right midmounting bracket (1) to flywheel
housing and tractor frame using HHCS M16 x 50MM (20) and M16 lockwashers (24).
2. Raise left midmounting bracket (2) with overhead hoist. Fasten left midmounting bracket (2) to flywheel
housing using HHCS M16 x 50MM (20) and M16 lockwashers (24).
3. Install the back axle bars (3) on both sides of the tractor with HHCS M16 X 60MM (22), M16 spring
washers (24) and M16 nut (26). Attaching them towards the center of the tractor in the back and towards
the outside of the tractor in the front.