Rhinotek F-4243C - Manual (Page 101)

MAINTENANCE
1625 01/11 Maintenance Section 5-3
© 2011 Alamo Group Inc.
MAINTENANCE
NEVER perform maintenance beneath a raised loader unless loader is properly supported
to prevent accidental lowering.
Do Not fill fuel tank while engine is running. Refuel only after engine has cooled down. If
fuel is spilled, move machine away from the area of the spill and avoid creating any source
of ignition until the fuel has evaporated.
(SBH-49)
Avoid contact with hot surfaces including hydraulic oil tanks, pumps, motors, valves and
hose connections. Relieve hydraulic pressure before performing maintenance or repairs.
Use gloves and eye protection when servicing hot components. Contact with a hot surface
or fluid can cause serious injury from burns or scalding.
(SG-34)
Use caution and wear protective gloves when handling sharp objects such as blades,
knives, and other cutting edges. Be alert to worn component surfaces which have sharp
edges. Sharp surfaces can inflict severe laceration injuries if proper hand protection is not
worn.
(SG-37)
Avoid contact with hot surfaces of the engine or muffler. Use gloves and eye protection
when servicing hot components. Contact with a hot surface or fluid can cause serious injury
from burns or scalding.
(SG-38)
Never allow anyone to get under the loader or attachment or to reach
through the loader lift arms when raised. Serious injury could result from
crushing or pinching by the loader or attachment.
(SL-06)
PARTS INFORMATION
Rhino products are designed utilizing specifically matched system components to ensure optimum equipment
performance. These parts are made and tested to Rhino specifications. Non-genuine "will fit" parts do not
consistently meet these specifications. The use of “will fit” parts may reduce equipment performance, void
warranties, and present a safety hazard. Use genuine Rhino parts for economy and safety.
(SPRM-2)
SEE YOUR RHINO DEALER