RCA CC417 - Manual (Page 45)

43
Specifications
General
Power requirement: 9.6VDC
Power consumption: 7 watts (normal)
Weight: 4.4 lbs. (2 kg)
Dimensions:
4-1/2"(W) x 8-1/8"(H) x 12-1/4"(D)
(111 x 205 x 311mm)
Video Recorder Section
Format: VHS
Record/Playback System:
Two video record/playback heads
One flying erase head
Headwheel Cylinder Diameter: 62 mm
Video Signal: EIA Standard NTSC
Color
Camera Section
Scanning: 525 Lines/60 Fields/30
Frames
Image Sensor: 1/4” high/resolution,
solid state CCD imager
Tripod Mount: One 1/4" x 20 threaded
hole
Lens: f1.6 — 12:1 (4-48mm)
Diameter: 46 mm
Adapter/Charger
Power Requirement: 120 V 50/60 Hz
Power Consumption: 30 Watts (max)
Weight: (390 grams)
Dimensions:
(78 x 52 x 155 mm)
Information to User
This digital apparatus does not exceed the
Class B limits for radio noise emissions from
digital apparatus as set out in the
interference-causing equipment standard
entitled “Digital Apparatus”, ICES-003 of the
Department of Communications.
Cet appareil numérique respecte les limites
de bruits radioélectriques applicables aux
appareils numériques de Classe B prescrites
dans la norme sur le matériel brouilleur:
“Appareils Numériques”, NMB-003 édictée
par le ministre des Communications.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Alterations or modifications carried out
without appropriate authorization may
invalidate the user’s FCC right to operate the
equipment.