Roland XP-80 - Manual (Page 17)

No. File name Song Name
10 PTNSET01.SVQ Acid Set
11 PTNSET02.SVQ Acid Swing Set
12 PTNSET03.SVQ Dancehall Set
13 PTNSET04.SVQ Euro Beat Set
14 PTNSET05.SVQ Funk Set
15 PTNSET06.SVQ Ground Beat Set
16 PTNSET07.SVQ Hip Hop Set
17 PTNSET08.SVQ House Set
18 PTNSET09.SVQ Jazz Set
19 PTNSET10.SVQ Lovers Set
20 PTNSET11.SVQ Trance Set
The produsers of all songs are Mitsuru Sakaue and Kiyotaka Takiyama . Copyright © 1995
Roland Corporation
✳ Roland Corporation holds the copyrights to all the Phrases of these Patterns. You may use these
Phrases when creating new works of your own without requesting permission from Roland.
Roland Corporation, however, assumes no responsibility or liability whatsoever with regard to
any infringements upon the copyrights of any third parties that may result through your use of
these materials.
✳ Refer to page 36 for the profile of the Producer.
❶ Insert the demo disk into the disk drive.
❷ Press [SEQUENCER].
❸ Make sure that the cursor is located at the song number, and select the demo song that you
wish to hear, either by turning the VALUE dial, or by pressing [INC]/[DEC] to select the song
number from 10–20.
If the cursor is elsewhere, move it using [u] or [d].
❹ Press [STOP/PLAY].
No sound will play, but the sounds to be used for Pattern playback will be selected. By putting
the XP-80 in playback mode, you can synchronize the timing at which each Pattern will begin
playback.
❺ Press various keys to play back the Patterns, referring to the figure below.
As long as you keep the key pressed, the pattern continues to play back. You can play back up
to eight Patterns simultaneously.
✳ The keys assigned to each pattern will vary slightly depending on the pattern collection select-
ed.
✳ To interrupt playback of the pattern, press a key lower than C2.
❻ To stop playback, press [STOP/PLAY] again.
Stop
C2
Drum Bass
Bass Fil in Others
17