RCA VR613HF - Manual (Page 33)

31
Back Panel
OUT TO TV
IN FROM
ANT.
VHF/UHF
3 CH. 4
IN
AUDIO1
VIDEO1
R
L
OUT
3 CH. 4 Switch
Selects the channel to which you tune the TV to see the
VCR picture if you connect the VCR using one of the basic
hookups.
IN FROM ANT. (Antenna) Connector
Receives a signal from an antenna or cable system when
attached.
OUT TO TV Connector
Passes the signal to the TV using the supplied cable.
VIDEO1 and AUDIO1 ( R and L ) IN Jacks
Receives signals from another component, such as a VCR or
camcorder, when it is connected to these jacks.
Press
INPUT on the remote to select and use these jacks.
VIDEO1 and AUDIO1 ( R and L ) OUT Jacks
Sends signals from the VCR to another component, such as a
monitor TV or another VCR, when it is connected to these jacks.
If the other component is not stereo, you may need a
Y-adapter to hear both channels.
References
Location of Controls
CHANNEL POWER TV•VCR
TRACKING
RECORD
REW FWD
STOP•EJECT
PLAY•PAUSE
CHANNEL or TRACKING up or down
Selects next higher or lower channel in the VCR’s channel
memory.
Adjusts tracking during playback.
FWD (Fast-Forward)
Fast-forwards the tape when the VCR is stopped.
Searches the picture forward during playback.
PLAY•PAUSE
Plays a tape.
Pauses the tape for stop-action viewing during playback.
Pauses the tape during recording to prevent recording
unwanted material.
POWER
Turns the VCR on or off.
RECORD
Starts the VCR recording.
Remote Sensor
Receives signals from the remote control. Aim the remote at
this sensor with no objects between them.
REW (Rewind)
Rewinds the tape when the VCR is stopped.
Searches the picture in reverse during playback.
STOP•EJECT
Stops the VCR’s normal functions such as record, playback,
rewind, fast-forward, or pause.
Press when the VCR is stopped to eject the cassette.
TV•VCR
Switches the picture signal so that it either comes from the VCR
or the TV channel.
See page 10.
Front Panel
Tape Compartment
Remote Sensor
continued on next page