Pre l iminar y – Runco 3DIMENSION D-73D User Manual
Page 26
10
D-73d Series Installation/Operation Manual
PRE
L
IMINAR
Y
1.
POWER INPUT (Left-Eye Engine – 100 to 240 VAC)
Connect the left-eye optical engine to power here.
2.
DHD INPUT (Left-Eye Engine)
An HDCP-compliant digital video input for connecting the HDMI Out (To Display)
from the Primary DHD Controller.
3.
RS-232C INPUT (Left-Eye Engine) (9-pin, female D-Sub)
Connect the Display Control output on the Primary DHD Controller to this input (see
Figure 2-5).
4.
STANDBY LED (Left-Eye Engine)
Indicates left-eye engine status as follows:
• Solid green = AC power present, ready to turn on.
• Flashing green = Projector is initializing; keypad functions not allowed.
• Off = Normal operation.
5.
ERROR LED (Left-Eye Engine)
Indicates left-eye engine error conditions as follows:
• Flashing red = Over temperature, user intervention (clear vents, turn on AC) may fix
problem
• Solid red = Error that requires servicing (fan failure, Power-on Self-Test (POST)
failure).
6.
ERROR LED (Right-Eye Engine)
This LED operates identically to the ERROR LED on the left-eye engine.
7.
STANDBY LED (Right-Eye Engine)
This LED operates identically to the STANDBY LED on the left-eye engine.
8.
RS-232C INPUT (Right-Eye Engine) (9-pin, female D-Sub)
Connect the Display Control output on the Secondary DHD Controller to this input.
9.
DHD INPUT (Right-Eye Engine)
An HDCP-compliant digital video input for connecting the HDMI Out (To Display)
from the Secondary DHD Controller.
10. POWER INPUT (Right-Eye Engine – 100 to 240 VAC)
Connect the right optical engine to power here.
11. CINEWIDE/AUTOSCOPE +12V TRIGGER OUTPUT
Connect the AutoScope anamorphic lens transport (if present) to this output.