Installing windows usb driver, Verifying usb connectivity in windows, Installing mac usb drivers – RCA SpeedTouch 536 User Manual
Page 28: Device settings, Chapter 2
Chapter 2
Local Network Setup
E-DOC-CTC-20050429-0099 v1.0
20
Installing Windows USB
driver
The installation is plug and play, meaning that installation will require almost no
effort.
Proceed as follows:
1
Insert the blue USB cable provided into the SpeedTouch™ USB port marked with
the USB logo:
2
The other end of the USB cable fits in (one of) the USB port(s) of your PC. In
most cases your PC's USB port is marked with the same USB symbol.
3
Windows will automatically recognise the Thomson USB Remote NDIS device:
4
The Windows Found New Hardware Wizard appears:
This wizard will guide you through the installation procedure of the USB drivers.
Click Next to continue.
5
Select Install the software automatically (Recommended), and click Next.
6
The USB driver is being installed. After a while a completing dialogue will
appear. Click Finish to complete the installation.
7
As a result your USB connection is installed and ready for use.
Verifying USB
connectivity in Windows
The SpeedTouch™ USB connection is represented as a local network interface. You
can easily check this interface by opening the Network Connections window from
Windows’ Control Panel:
Installing Mac USB
drivers
The USB driver will be installed automatically on your Mac.
Device settings
Once you’ve connected a device, you are able to personalise its settings. For more
information, see
.
You can also connect your PC to the SpeedTouch™ via a USB hub.
The Windows Found New Hardware Wizard may ask your
authorisation to connect to Window Update to search for software. If
this is the case, select No, not this time and click Next.
On the Setup CD, the Mac USB driver is located in stInstall.app > Contents >
MacOS > CDCdriver
.