Power up mode, Common address – Runco DTV-1200 User Manual
Page 62
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS:
0
Select with or
then
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE:
operating
COMMON ADDRESS: 0
Select with or
then
60
Power Up Mode
What can be done?
When pressing the power switch, the projector can start up in 'operating mode' or in 'stand-by mode'.
Operating mode: the projector start up and displays image.
Stand-by mode: the projector start up in stand-by and waits until the stand-by button or a digit key is pressed.
How to change the mode?
To change the Power up mode:
1. Push the cursor key or to highlight Power Up (menu 1).
2. Press ENTER to toggle between 'Operating' and 'Standby'.
menu 1
What can be done?
Every projector listens to a common address. This common address can be set to '0' or '1'. When a Remote is
programmed with a common address, every projector with that same common address will follow up the com-
mands given by that Remote.
Why 2 different common address?
The reason to have the choice to select between common addresses is, to avoid controlling of other IR con-
trolled units, e.g. a TV set with standard common address 0.
How to change the common address?
1. Push the cursor key or to highlight Common Address (menu 1).
2. Press ENTER to toggle between '0' and '1'.
Common Address
Note: Runco recommends that this be left in
‘Standby’ for long-term reliability.
menu 1