Raypak D-2 POWER VENT 206A - Manual (Page 7)

7
INSTALLATION (Continued)
13. Install the right side outdoor conduit through the top 7/8” hole located on the right side of the heater.
See. Fig. 13. Note: You must first remove the 7/8” plug on the heater to install the hard conduit.
14. Wire the heater power lines along with the D-2 Power Vent power lines to the supply power per the wiring
diagram. (See page 15 or 16.)
15. Reinstall the transformer cover. See Fig. 12.
16. Install the left side outdoor conduit through the top 7/8” hole located on the left side of the heater. See
Fig. 14. Note: You must first remove the 7/8” plug on the heater to install the conduit.
17. Remove the (4) Phillips screws that hold the control panel to the heater and lower the control panel. See
Fig. 15.
18. Remove and replace the 7/8” plug with the provided 7/8” grommet (located on the left side of the control
panel). See Fig. 16.
Power
Vent
Power
Supply
Fig 13 Fig 14
Fig 15 Fig 16
Access
Screw
Access
Screw
7/8”
Supplied
Grommet