Raypak D-2 POWER VENT 206A - Manual (Page 6)

6
INSTALLATION (Continued)
6. Lower the jacket top back onto the heater and reinstall the (6) Phillips screws. See Fig. 3.
7. If installing on a model 266, 267, 406 or 407 heater, skip step 8.
8. Turn the Power Vent upside down. Using a 5/16” nut driver, relocate the mounting brackets as shown in Fig. 8.
9. Place the Power Vent on top of the heater. See Fig. 9.
10. Move the Power Vent, so that the collar adapter slips into the Power Vent. See Fig. 10.
11. Push in all four bracket tabs, so the Power Vent locks into position. See Fig. 11.
12. Using a 5/16” nut driver, remove the transformer cover located on the right side of the heater.
See Fig. 12.
Rear of
Heater
Fig 7 Fig 8 Fig 9
Fig 10 Fig 11 Fig 12
Front of
Heater
Tab Tab
Access
Screw
Before
After