Raypak D-2 POWER VENT 206A - Manual (Page 3)

3
RECEIVING EQUIPMENT
On receipt of your equipment, it is suggested that you visually check for external damage to the carton.
If the carton is damaged, it is suggested that a note be made on the Bill of Lading when signing for equipment.
Remove the complete assembly from the carton. If it is damaged, report the damage to the carrier immediate-
ly. Be sure that you receive the number of packages indicated on the Bill of Lading. Claims for shortages and
damages must be filed with the carrier by consignee.
Purchased parts are subject to replacement only under the manufacturerʼs warranty. Debits for defec-
tive replacement parts will not be accepted and defective parts will be replaced in kind only per our standard war-
ranties.
When ordering parts, you must specify the kit number. When ordering under warranty conditions, you
must also specify the date of installation.
The manufacturer recommends that this manual be reviewed thoroughly before installing the D-2 Power
Vent. If there are any questions which this manual does not answer, please contact you local Representative.
THIS MANUAL SHOULD BE MAINTAINED IN LEGIBLE CONDITION AND KEPT ADJACENT TO THE UNIT.
(1) D-2 POWER VENT
(1) COLLAR ADAPTER
(1) 7/8” PLASTIC GROMMET
(1) ADJ. 90° ELBOW W/ SCREEN
(1) INSTALLATION AND OPERATING INSTRUCTIONS
(P/N 241243)
(1) 4” ADAPTER
The D-2 Power Vent is tested and certified to the latest edition of the American National Standard ANSI
Z21.56 standard for pool heaters.
The D-2 Power Vent is a fan-assisted combustion system designed for application to heater models 206
thru 407. When installed as directed, the unit is capable of operating in applications such as through-the-wall
venting and reduced horizontal and vertical vent pipe sizes in new and existing installations.
The D-2 Power Vent includes a blower with a 120/240 volt 60Hz 1.95/1.0A 3200 RPM motor and a
plenum, complete with a draft proving switch and a motor relay.
HEATER
MODELS
FACTORY-
WIRED
D-2 POWER VENT
PART NO.
206/207 - 266/267 240 VAC 009832
336/337 - 406/407 240 VAC 009833
206/207 - 266/267 120 VAC 010744
336/337 - 406/407 120 VAC 010745
GENERAL SPECIFICATIONS
D-2 Power Vent
(with Adapter in place) Elbow with Screen Collar Adapter
Comes separated
(assembles together)
4” Adapter