Raypak D-2 POWER VENT 206A User Manual

Page 5

INSTALLATION

1. Start off by disconnecting main power to the heater.

2. Remove the front door from the heater. See Fig 1.

3. If this is a retro-fit application, remove existing “Pagoda Top” and discard. See Fig. 2. If equipped with a

drafthood, refer to drafthood installation manual for removal process.

4. Remove the (6) Phillips screws that hold the jacket top to the heater. See Fig. 3.

5. Lift the rear end of the jacket top while inserting the collar adapter. See Fig. 4 & 5.

Note: Brackets are positioned underneath the collar adapter to capture the smaller model, See Fig. 6. Also

note the orientation of the adapter on the heater as shown in Fig. 7.

Pagoda Top

(3) on

other side

Fig 1

Fig 2

Fig 3

Fig 4

Fig 5

Fig 6

Brackets used only on

206/207/336/337 models to

hold collar adapter in place

Remove door by unfastening

knurled screw shown.