Radio Shack TAD-1029 - Manual (Page 9)

9
2. Plug one end of the supplied short
modular cord into the telephone jack
on the back of the base.
3. Insert the supplied AC adapter’s
barrel plug into the DC 12V jack on
the back of the base.
4. Route the modular cord through ei-
ther groove on the right bottom of
the base and the adapter cord
through the groove below the strain
relief slot.
5. Route the end of the modular cord
through the hole in the bracket, and
insert the tabs on the narrow end of
Strain
Relief
Slot
the bracket into the inner pair of
slots near the top of the base as
shown.
6. Snap the tabs at the wide end of the
bracket into place.
7. Plug the modular cord into the wall
plate jack. Align the base’s keyhole
slots with the wall plate studs and
slide the base downward to secure
it.
43-789.fm Page 9 Monday, August 16, 1999 8:32 AM