Radio Shack TAD-1029 - Manual (Page 23)

23
Using the Handset
1. Press REMOTE . The REMOTE indi-
cator lights and –– appears on the
base.
2. Press CHANGE ( ) then ANNC (0) .
The handset beeps once.
3. Speak your message in a normal
voice, as though you were talking to
someone on the phone.
4. Press STOP (5) when you finish the
message. The TAD plays back the
outgoing message, then beeps
twice.
5. Press REMOTE . The REMOTE indi-
cator turns off.
To play the outgoing message at any
time, press
REMOTE then ANNC .
Using the Base
1. Hold down ANNC . After 3 seconds
the TAD beeps and –– flashes.
Continue holding down ANNC and
speak your message in a normal
voice about 8 inches from the front
of the base.
2. Release ANNC when you finish the
message. PL (play) appears and
the TAD automatically plays back
the message.
To play the outgoing message at any
time, press
ANNC . PL appears while the
message plays.
Deleting an Outgoing Message
To delete your outgoing message and
use the prerecorded message, press
DELETE then ANNC on the base, or RE-
MOTE , DELETE (9) , then ANNC on the
handset.
REMOTE Indicator
43-789.fm Page 23 Monday, August 16, 1999 8:32 AM