Radio Shack TAD-1029 - Manual (Page 27)

27
DELETING MESSAGES
To delete the current message during
playback, press
DELETE on the base or
handset.
Note: You can replay a deleted mes-
sage by repeatedly pressing
REPEAT on
the base or handset before the TAD an-
nounces “End of messages.”
To delete all messages in a mailbox or
the message center after playback,
press
DELETE then the mailbox or mes-
sage center button. The TAD beeps.
Note: The TAD-1029 does not delete
unplayed messages.
CHANGING THE REMOTE
OPERATION SECURITY
CODE
To use your TAD from a remote tele-
phone, you must first enter a 2-digit re-
mote operation security code. The
security code for your TAD is preset to
50. You can use the preset code, or fol-
low these steps to change it.
Note: In Step 2 you must begin entering
the new code within 20 seconds. Other-
wise, the TAD sounds 5 short beeps and
2 long beeps and stops the process. If
this happens, simply repeat Step 2.
1. Press REMOTE on the handset. The
REMOTE indicator lights.
2. Press CHANGE ( ) then CODE (7) .
The TAD announces “Enter new
code.” Enter a new two-digit remote
operation security code. The TAD
announces “New code is xx” and
beeps twice.
3. Press REMOTE . The REMOTE indi-
cator turns off.
To check the remote operation security
code, press
REMOTE then CODE. The
TAD announces “Code is xx” and beeps
twice.
REMOTE Indicator
43-789.fm Page 27 Monday, August 16, 1999 8:32 AM