Radio Shack TAD-1029 User Manual

Page 8

4. Insert the supplied AC adapter’s

barrel plug into the

DC 12V

jack on

the back of the base.

5. Route the adapter’s cord through

the strain relief slot on the back of
the base.

6. Insert the tabs on the narrow end of

the bracket into the inner pair of
slots near the bottom of the base as
shown and snap the tabs at the wide
end of the bracket into place.

7. Plug the adapter into a standard AC

outlet. The message counter counts
down from

and the TAD-

1029 beeps.

8. Fully extend the base’s antenna and

place it in a vertical position.

Mounting the Base on a Wall
Plate

1. Remove the mounting bracket by

holding in both tabs and gently pull-
ing out the wide end of the bracket.

Strain
Relief
Slot

43-789.fm Page 8 Monday, August 16, 1999 8:32 AM