Roland VS-700R - Manual (Page 20)

20
Audio Clock Source
You can choose one of four types of clock source. The current clock source is shown by the front panel SYNC
indicator.
In the case of an external source, the indicator will light if synchronization is locked. The indicator will blink if
synchronization is not locked
If you’re using SONAR, you can select the clock source parameters as described below.
If you’re using software other than SONAR, use “VS-700R I/O Editor” which is included on the “SONAR V-
STUDIO 700 CD-ROM.”
1. From SONAR’s “Tools” menu, open “VS-700.”
2. Select the “MIC PRE” tab.
3. Click the “SYNC” check box to select the clock source.
If you’re adding a second VS-700R unit, set the INTERFACE field to “2.”
These settings are not stored in the VS-700.
Setting Screen label Explanation
Internal clock INTERNAL The internal clock will be used as the master clock.
Digital 1 DIGITAL 1 Synchronized to the clock of the digital audio signal being input to Digital 1.
Digital 2 (ADAT) DIGITAL 2 Synchronized to the clock of the digital audio signal being input to Digital 2.
Word clock WORDCLK
Synchronized to the word clock signal being input to the word clock input
connector.
VS-700R_e1.book 20 ページ ２０１０年６月１５日 火曜日 午後４時５９分